Macon ENTL
The sensor is wax-filled and the wax varies according to ambient temperature. The volume changes are transmitted to the valve stem via a liquid capillary system. The valve body has a return spring which closes the valve when the stem is under low pressure. When the force from the sensor and the return spring are balanced to the room temperature selected, the valve disc stops in that position to allow a certain amount of water to flow through the valve. Temperature changes cause the valve disc to change position and thereby continuously modulate the flow so that the room temperature is maintained at the desirable temperature. The unit is secured against damage from over pressure by a pressure absorbing spring.
Brass sensor High sensitivity
Fully automatic - nonelectric No wiring - nonelectric operation
Small Dimensions Simple one-trade installation
Stainless steel capillary tube (78") Fits all Macon NT series valves
Manufactured to exacting standards using exceptionally high quality materials Remote setting knob and temperature sensor
Note that all changing of the actuator can be accomplished without draining the system Each sensor is tested and re-checked to achieve exact settings before leaving the factory
All Macon thermostats can be locked at or limited to a specific temperature or temperature range Replaces the valve-mounted sensors on built-in convectors, etc., and where the valve-mounted sensor is exposed to draft from windows or doors.
Fiberglass valve plug shaft